NEC Electra Elite IPK - Access Code (1-Digit) Assignment

Electra Elite IPK Document Revision 4
Programming Manual 2 - 51
___________________________________________________________________________________
___________________________________________________________________________________
1-1-46 Access Code (1-Digit) Assignment
General Description
Use this Memory Block to assign a 1-digit number as an Access Code or station
number.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
DF to access the Memory Block.
3 Enter the options using the dial pad.
 Use the following when entering data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
4 Enter the Function Number for the Dial Number. Refer to the table on the following pages for a complete list.
5 Press
G to write the data and display the next Dial No.
6 Program each Dial No., and press
G after the last Dial No. to display the next Memory Block.
7 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-47
Access Code (2-Digit) Assignment
1-1-48
Access Code (3-Digit) Assignment
System Mode
1
Submode
1
Data No.
46
PC Programming
¦ +BA
4 6 : 1 D G ( 0 ) = 1 7 6
T I M E D I S P L A Y
Function
No.
Data
No.
Dial
No.
0~9
* #
Title
Default Values
Dial No.
Function
No.
Function Name
K 176 Specified Intercom Call
A ~ C 001 Station Number
D ~ G 000 Not Used
H 102 Trunk Group 2
I 101 Trunk Group 1
J 096 Last Number Redial
L 026 Callback Message Answer