NEC Electra Elite IPK - Automated Attendant Message to Tenant Assignment

2 - 164 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-4-12 Automated Attendant Message to
Tenant Assignment
General Description
Use this Memory Block to assign Automated Attendant Messages to a Tenant.
Display
Related Programming
Refer to individual features in the Electra Elite IPK Features and Specifications Manual.
 Notes 
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 +
JJAB to access the Memory Block.
3 Use the dial pad to change the Tenant for AA MSG1.
K ~ I to enter Tenant Number
Default Values
All Automated Attendant Messages:
Tenant No. 00
4 Press G to write the data, and advance to the next message.
5 Repeat Steps 3 and 4 for all AA messages. The next Memory Block is displayed.
6 Program the next Memory Block or press
E to go back on-line.
When a tenant is not assigned to a specific automated message, the Automated Attendant sends the message
assigned in Memory Block 1-4-11 (Automated Attendant Message Day/Night Mode Selection).
System Mode
1
Submode
4
Data No.
12
PC Programming
¦ +AU
1 2 : A A 1 T N A T = 0 0
T I M E D I S P L A Y
Title
Data
No.
AA MSG
(1~8)
Setting
Data