NEC Electra Elite IPK - SLT Hookflash Assignment

2 - 534 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
4-24 SLT Hookflash Assignment
General Description
Use this Memory Block to either Hold or disconnect the trunk for the Single Line
Telephone (SLT) hooking operation.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
HOLD DISC
Programming Procedures
1 Go off-line.
2 Press LK4 +
BD to access the Memory Block.
3 Press the corresponding CO/PBX line key to change data option.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B + A to enter A for Port Numbers 100~109
B + B to enter B for Port Numbers 110~119
B + C to enter C for Port Number 120
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-3-02
SLT Hookflash Signal Selection
4-23
Prime Line/Hot Line Assignment
Telephone Mode
4
Submode
—
Data No.
24
PC Programming
¦ +BTI
Data
No.
0 1 / 2 4 : S L T H K H O L D
T I M E D I S P L A Y
Title
Tel
Port
No.
(01
~ C0)
Setting
Data