NEC Electra Elite IPK - Intercom Call Voice;Tone Signal Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 107
___________________________________________________________________________________
___________________________________________________________________________________
1-2-01 Intercom Call Voice/Tone Signal
Selection
General Description
Use this Memory Block to specify whether signal tone or voice is used first for an
intercom call.
Display
Settings
 Notes 
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
TONE VOICE
Programming Procedures
1 Go off-line.
2 Press LK1 + LK2
+ KA to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-6-03
DSS Call Voice/Tone Signal Selection
1. To switch from voice to tone signaling or from tone to voice, dial a station number, then dial 1.
2. When tone signaling is programmed in this Memory Block, the called party cannot answer handsfree unless the
originator of the call dials 1.
3. This Memory Block has no effect on incoming Voice Announcement Tie/DID line calls. Refer to Memory Block
1-1-34 (Tie Line First Ring Pattern Selection).
System Mode
1
Submode
2
Data No.
01
PC Programming
¦ +BI
0 1 : V O I C E C A L L
T I M E D I S P L A Y
Setting
Data
Title
Data
No.