Electra Elite IPK Document Revision 4
Programming Manual 2 - 577
___________________________________________________________________________________
___________________________________________________________________________________
4-58 Automated Attendant Selection for
DID
General Description
Use this Memory Block to specify the Automated Attendant message for DID calls.
Display
Settings
Page 1
Notes
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
The shaded
selection is the
default.
NON AA1 AA2 AA3 AA4 AA5 AA6 AA7
Page 2
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
AA8
Programming Procedures
1 Go off-line.
2 Press LK4 +
EH
to access the Memory Block.
3 Press the line key to specify Automated Attendant priority for Tel port No.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
C to go to the next page
A to go to the previous page
B +
A
to enter A for Port Numbers 100~109
B +
B
to enter B for Port Numbers 110~119
B +
C
to enter C for Port Number 120
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Telephone Ports A0~C0 are ports 100~120.
CO/PBX Line Mod
To Next Page
Loading...
