NEC Electra Elite IPK - DID Digit Conversion Assignment

2 - 28 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-1-21 DID Digit Conversion Assignment
General Description
Use this Memory Block to enable the DID Digit Conversion Table, Memory Block
1-1-22 (DID Digit Conversion Table), for each number.
Display
Settings
 Notes 
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8The shaded
selection is the
default.
NO YS
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK1 + BA to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Default Values
NO
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-20
DID Digit Length Selection
1-1-22
DID Digit Conversion Table
1-1-23
DID Forward Station Number for Busy Station or Undefined Digit
5-00
Digit Add/Del For Tie Line Networking Assignment
1. When NO is assigned, only Memory Block 5-00 has an impact on incoming DID numbers.
2. When YS is assigned, each incoming DID number can be modified.
System Mode
1
Submode
1
Data No.
21
PC Programming
¦ +ALN
2 1 : D I D C N V N O
T I M E D I S P L A Y
Setting
Data
Title
Data
No.