NEC Electra Elite IPK - Before Programming; Check Points; Preliminary Points; Section 2 Programming the System

1 - 4 Multiline Terminal Programming
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
2.3 Before Programming
The technician should check the ROM version and the port numbers before
programming the system.
2.3.1 Check Points
H Confirm the ROM Version
The available features depend on the ROM version. Refer to
Memory Block 8-1 (ROM Version Confirmation), or from any
idle Display Terminal, press
A and C .
H Confirm the Port Number
Port numbers are used for system programming. Refer to
Memory Block 7-1 (Card Interface Slot Assignment).
To confirm station numbers press A and D . The display
indicates the station number and the port number.
2.3.2 Preliminary Points
H Select System Programming
Refer to Section 2 Programming the System on page 1-1.
LK 8 Special Mode
LK 1 ROM Version Confirmation
LK 2 System Speed Dial Memory Clear
LK 3 Station Speed Dial Memory Clear
LK 8 Second Initialization
Table 1-1 Programming Modes (Continued)
Line
Key
Mode Name
Line
Key
Submode Name
# # # = T E L X X
T I M E D I S P L A Y
Station
Number
Port
Number