NEC Electra Elite IPK - Automated Attendant Extension Number Assignment

Electra Elite IPK Document Revision 4
Programming Manual 2 - 175
___________________________________________________________________________________
___________________________________________________________________________________
1-4-21 Automated Attendant Extension
Number Assignment
General Description
Use this Memory Block to specify the Automated Attendant message to be played
when a DID call is received.
Display
 Notes 
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 +
JJBA to access the Memory Block.
3 Enter Setting Data using the dial pad for AA MSG 1.
 Use the following:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
2-Digit Station Number: 10~89
3-Digit Station Number: 100~899
4-Digit Station Number: 1000~8999
H to clear all data when cursor is at setting position
Default Values
No Message Specified
4 Press G to write the data and advance to the next AA MSG.
5 Repeat Steps 3 and 4 for each AA MSG. The next Memory Block is displayed.
6 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-46,47
Access Code (1-Digit, 2-Digit) Assignment
1-2-03
2-, 3-, or 4-Digit Station Number Selection
This number is the same as Extension Number, CAR key number, and ACD/UCD/SCD. Pilot number cannot be
assigned.
System Mode
1
Submode
4
Data No.
21
PC Programming
¦ + AU
2 1 : A A M S G 1 =
T I M E D I S P L A Y
AA MSG
1~8
Setting
Data
Data
No.
Title