NEC Electra Elite IPK - Class of Service (Station) Feature Selection 2

2 - 212 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
 Notes 
Programming Procedures
1 Go off-line.
2 Press LK1 + LK8 +
KG to access the Memory Block.
3 Press the corresponding CO/PBX line key to enter data.
The LED indication changes to indicate the data each time a CO/PBX line key is pressed.
 Use the following when entering data:
Press
C to go to the next page.
Press
A to go to the previous page.
4 Press
G key. Data for Class 01 ~ 15 is displayed successively.
5 Press
G to write the data for Class 15. The next Memory Block is displayed.
6 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-8-08
Class of Service (Station) Feature Selection 2
4-17
Station to Class of Service Feature Assignment
1. System-Wide Reset selection resets the following: Call Forward – All Call, Do Not Disturb, Customized Message,
and Callback Request.
2. Password (Outgoing Restriction) selection cancels Station Lockout and default password for another station.
3. Sixteen Classes (00
~ 15) of feature restriction patterns allow a station user to activate particular features while
restricting others.
4. At default, stations 100 and 101 are in class 00. All other stations are in class 15.
5. Stations are assigned to a Class of Service in Memory Block 4-17 (Station to Class of Service Feature
Assignment).
CO/PBX
Line Key LED
Off On
Data Deny
Allow
The shaded area indicates
the default setting.