NEC Electra Elite IPK - 1-16-02 Port Duplex Mode Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 383
___________________________________________________________________________________
___________________________________________________________________________________
1-16-02 Port Duplex Mode Selection
General Description
When Memory Block 1-16-00 (Auto Negotiation Yes/No Selection) is set to NO, use
this Memory Block to specify duplex mode (HALF or FULL) for each port of each
HUB(8)-U( ) ETU.
R1500 or higher is required.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
HALF FULL
Programming Procedures
1 Go off-line.
2 Press LK1 + LK16 +
JJKB to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press
G to write the data.
5 Repeat steps 3 and 4 for each port of each HUB(8)-U( ) ETU.
6 Press
E to go back on-line.
System Mode
1
Submode
16
Data No.
02
PC Programming
¦ +AB
0 2 : 1 - 1 H A L F D U P L
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
PORT
1~8
HUB
1~3