NEC Electra Elite IPK - LCR Class to Trunk Group Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 613
___________________________________________________________________________________
___________________________________________________________________________________
5-04 LCR Class to Trunk Group Selection
General Description
Use this Memory Block per trunk group to specify the Least Cost Routing (LCR)/
Automatic Route Selection (ARS) Class. For systems connected using K-CCIS, the
Electra Elite can analyze incoming telephone numbers received from a distant system
and use the LCR/ARS assignments to route the call to its desired destination.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
01234
Programming Procedures
1 Go off-line.
2 Press LK5 +
G + KD to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press
G to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
3-70
CIC Number Assignment
1-1-05
Start Time Selection
1-1-46~48
Access Code (1-, 2- or 3-Digit) Assignment
1-15-00
K-CCIS Main/Remote Office Selection
1-15-01
Common Signal Channel Data Speed Assignment
1-15-02
Common Signal Channel Assignment
1-15-03
Originating Point Code Assignment
1-15-04
Destination Point Code Assignment
1-15-05
Destination Point Code Transfer Assignment
1-15-06
Originating Office Code Number Assignment
Trunk Group Mod
e
5
Submode
Data No.
04
PC Programming
¦ +AW
0 1 / 0 4 : C L A S S 0
T I M E D I S P L A Y
Trunk
Group
(01~32)
Setting
Data
Title
Data
No.