NEC Electra Elite IPK - IP Telephone Block Assignment

Electra Elite IPK Document Revision 4
Programming Manual 2 - 131
___________________________________________________________________________________
___________________________________________________________________________________
1-2-32 IP Telephone Block Assignment
General Description
Use this Memory Block to specify when IP Telephones that connect to the
IPCA( )-U( ) ETU must use resources from the CPUI( )-U( ) ETU (Legacy system).
When IP Telephone Blocks are assigned, the CPUI( )-U( ) ETU can control the
following features for the IPC IP Telephones:
H Centralized Billing (K-CCIS)
H Code Restriction
H Enhanced 911
H ISDN-PRI Trunk Connections – Calling Party Number (CPN) Presentation from Station
H Least Cost Routing (LCR)
H Station Message Detail Recording (SMDR)
System Software R2500 is required.
Display
Settings
Page 1 Ports 01~32
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
Default: No PS
Telephone
Blocks are
assigned.
Port 01~04 Port 05~08 Port 09~12 Port 13~16 Port 17~20 Port 21~24 Port 25~28 Port 29~32
Page 2 Ports 33~64
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Port 33~36 Port 37~40 Port 41~44 Port 45~48 Port 49~52 Port 53~56 Port 57~60 Port 61~64
Page 3 Ports 65~96
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Port 65~68 Port 69~72 Port 73~76 Port 77~80 Port 81~84 Port 85~88 Port 89~92 Port 93~96
Page 4 Ports 97~C0
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Port 97~A0 Port A1~A4 Port A5~A8 Port A9~B2 Port B3~B6 Port B7~C0
LED Status Off On (Green) On (Red)
Default is shaded, and no IP Phone
Blocks are Assigned.
Data Not Assigned IP Assigned)
Block Not
Available
System Mode
1
Submode
2
Data No.
32
PC Programming
¦ +AH
3 2 : I P A S S I G N | 0 1
T I M E D I S P L A Y
Setting Data
Data 00~CO
Title
Data
No.