NEC Electra Elite IPK - Automated Attendant Function Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 481
___________________________________________________________________________________
___________________________________________________________________________________
3-59 Automated Attendant Function
Selection
General Description
Use this Memory Block to specify whether the Automated Attendant is to operate in
the Normal DISA Mode or in the Delay Announcement mode.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
NORMAL DELAY
Programming Procedures
1 Go off-line.
2 Press LK3 +
G + EI to access the Memory Block.
3 Press LK2 to Delay Announcement Mode on CO/PBX No.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
4 Press
G to write the selected data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-4-18
Automated Attendant Delay Announcement Assignment
1-4-19
Automated Attendant 1st to 2nd Delay Announcement Interval Time Selection
1-4-20
Automated Attendant Delay Announcement Disconnect Time Selection
CO/PBX Line Mod
e
3
Submode
—
Data No.
59
PC Programming
¦ +AU
0 1 / 5 9 : A . A . N O R M A L
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Setting
Data