NEC Electra Elite IPK - Enhanced 911 Dialing Digit Assignment

2 - 254 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-8-46 Enhanced 911 Dialing Digit
Assignment
General Description
Use this Memory Block to specify the number of digits to be sent when a call is
originated by dialing 911.
System Software R2000 or higher is required to assign 9911.
Display
Settings
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK8 The shaded
selection is the
default.
1 11 911 9911
Programming Procedures
1 Go off-line.
2 Press LK1 + LK8 +
DF to access the Memory Block.
3 Press the corresponding CO/PBX line key to assign the value.
4 Press
G to write the data. The next Memory Block is displayed.
5 Program next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number
Memory Block Name
1-8-43
Enhanced 911 Trunk Assignment
1-8-44
Enhanced 911 Alternate Route Assignment
1-8-45
Enhanced 911 Alternate Route Assignment (Maintenance Busy)
1-15-19
Centralized 911 Allow/Deny Selection
1-15-20
Centralized 911 Originating Number Selection
1-15-21
Centralized 911 Look Ahead Routing Allow/Deny Selection
4-54
Enhanced 911 CESID to Station Table
System Mode
1
Submode
8
Data No.
46
PC Programming
¦ +AE
4 6 : 9 1 1 D I A L 9 9 1 1
T I M E D I S P L A Y
Setting
Data
Title
Data
No.