NEC Electra Elite IPK - Trunk Incoming Answer Mode Selection

2 - 430 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
3-05 Trunk Incoming Answer Mode
Selection
General Description
Use this Memory Block to specify the incoming answer mode (Automatic
Trunk-to-Trunk Transfer, Automated Attendant, or DISA) per outside line.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
NO ASSIGN TANDM TRF A A
Programming Procedures
1 Go off-line.
2 Press LK3 +
G + KE to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option for CO/PBX No.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
 Setting Data:
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
CO/PBX Line Mod
e
3
Submode
—
Data No.
05
PC Programming
¦ +BCT
0 1 / 0 5 : N O A S S I G N
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Setting
Data
Line
Key
LCD Indication
when Selected
Definition
LK 1 NO ASSIGN Normal
LK 2 TANDM TRF Automatic Trunk-to-Trunk Transfer
LK 3 A A Automated Attendant/DISA