NEC Electra Elite IPK - 1-16-10 Port Mirroring Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 399
___________________________________________________________________________________
___________________________________________________________________________________
1-16-10 Port Mirroring Selection
General Description
Use this Memory Block to specify whether or not Port Mirroring is enabled for each
HUB(8)-U( ) ETU. The source port and the target port must be members of the same
VLAN(s).
R1500 or higher is required.
Display
Settings
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
The shaded
selection is the
default.
NO
(Normal)
YS
(Mirror)
Programming Procedures
1 Go off-line.
2 Press LK1 + LK16 +
JJAK to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the option.
4 Press
G to write the data.
5 Repeat steps 3 and 4 for each HUB(8)-U( ) ETU.
6 Press
E to go back on-line.
System Mode
1
Submode
16
Data No.
10
PC Programming
¦ +AB
1 0 : 1 M I R R O R N O
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
HUB
1~3