NEC Electra Elite IPK - ARS Digit Add Assignment; ARS Digit Add Assignment (Memory Block 1-14-06); ARS Digit Delete Assignment; ARS Digit Delete Assignment (Memory Block 1-14-05)

Electra Elite IPK Document Revision 4
Programming Manual 3 - 17
___________________________________________________________________________________
___________________________________________________________________________________
Trunk Group 1 origination (NORMAL) is used in the USA. When the
call is not originated by pressing the line key or by dialing an access
code of Trunk Group 1, and the LCR Class assignment is 0, the call
is originated as is.
Default: NORMAL
2.3.8 ARS Digit Delete Assignment (Memory Block 1-14-05)
Use this Memory Block to specify number of digits (00~10) from the
first digit that are deleted from the route assignment.
Default: 00 (None)
2.3.9 ARS Digit Add Assignment (Memory Block 1-14-06)
Use this Memory Block to specify a maximum of 10 digits to add to
the route assignment.
Default: Not Assigned
2.3.10 ARS Max Digit Assignment (Memory Block 1-14-07)
Use this Memory Block to specify the number of digits to be collected
by the system before the message is sent to the network.
Default: Not Specified
2.3.11 Trunk-to-Trunk Group Assignment (Memory Block 3-03)
Use this Memory Block to assign a Trunk Group number to each CO/
PBX line.
Default: CO/PBX lines 01~08 in Trunk group 1
2.3.12 Trunk Type Selection (Memory Block 3-91)
Use this Memory Block to specify an external line as CO, PBX,TIE,
DID or CTX.
Default: CO
2.3.13 LCR Class Selection (Memory Block 4-40)
Use this Memory Block to specify the LCR/ARS class for each
station. The class number is the number of the Area Code Table
used. Stations cannot have multiple classes. Four area code tables
are provided. The MIFM-U( ) ETU with attached KMM(1.0)U must be
installed to support this feature.
Default: Class 0 (No LCR)