2 - 588 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
4-67 IP Station Number Assignment
General Description
Use this Memory Block to assign a station number for each IP telephone supported by
the IPCA( )-U( ) ETU.
System Software R2500 is required.
Display
Programming Procedures
1 Go off-line.
2 Press LK4 +
FG
to access the Memory Block.
3
Use dial pad to assign a 2- (10~89), 3- (100~899) or 4-digit (1000~8999) station number for each Tel Port No.:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B +
A
to enter A for Port Numbers 100~109
B +
B
to enter B for Port Numbers 110~119
B +
C
to enter C for Port Number 120
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
CO/PBX Line Mod
To Next Page
Loading...
