NEC Electra Elite IPK - Trunk Group Mode Copy Assignment

Electra Elite IPK Document Revision 4
Programming Manual 2 - 625
___________________________________________________________________________________
___________________________________________________________________________________
6-5 Trunk Group Mode Copy Assignment
General Description
Use this Memory Block to enable copying data from one Trunk group to another Trunk
group or multiple consecutive Trunk groups.
Display
Example: To copy data of Trunk Group 01 to Trunk Groups 10~14:
1. Enter the original Trunk Group. Using the dial pad, press
KA .
2. Press
G .
3. Enter the Trunk Group. Using the dial pad, press
AK ~ AD .
Programming Procedures
1 Go off-line.
2 Press LK6 + LK5
to access the Memory Block.
3 Enter the Trunk group to be copied.
 Use the following to enter data:
K ~ I to enter numeric data
H to clear all data when placed at cursor position
Copy Mode
6
Tenant
5
Data No.
—
T R K G P – – >
T I M E D I S P L A Y
Title
Original
Trunk Group No.
(01~32)
Setting
Data
T R K G P 0 1 – – >
T I M E D I S P L A Y
– – > T R K G P –
T I M E D I S P L A Y