2 - 372 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-15-19 Centralized 911 Allow/Deny Selection
General Description
Use this Memory Block to assign the Electra Elite IPK installed as a Main Office to
send the Calling Party Number out the CAMA trunk when an emergency 911 call is
originated from a remote K-CCIS office.
This Memory Block is used at the main office and tandem offices.
R2000 or higher is required.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
NO (Deny) YS (Allow)
Programming Procedures
1 Go off-line.
2 Press LK1 + LK15 +
AI
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press
G to write the data, and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-8-43
Enhanced 911 Trunk Assignment
1-8-44
Enhanced 911 Alternate Route Assignment
1-8-45
Enhanced 911 Alternate Route Assignment (Maintenance Busy)
1-8-46
Enhanced 911 Dialing Digit Assignment
1-15-20
Centralized 911 Originating Number Selection
1-15-21
Centralized 911 Look Ahead Routing Allow/Deny Selection
4-54
Enhanced 911 CESID to Station Table Assignment
System Mode
1
Submode
15
Data No.
19
PC Programming
¦
+AW
1 9 : C E N 9 1 1 N O
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
To Next Page
Loading...
