NEC Electra Elite IPK - Trunk-To-Trunk Transfer Yes;No Selection

2 - 428 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
3-04 Trunk-to-Trunk Transfer Yes/No
Selection
General Description
Use this Memory Block to specify whether or not to allow Trunk-to-Trunk Transfer.
Display
Settings
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8The shaded
selection is the
default.
NO YES
Programming Procedures
1 Go off-line.
2 Press LK3 +
G + KD to access the Memory Block.
3 Press the corresponding CO/PBX Line Key to change the option.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
CO/PBX Line Mod
e
3
Submode
—
Data No.
04
PC Programming
¦ +BCT
0 1 / 0 4 : T R F N O
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Setting
Data
Title
Data
No.