NEC Electra Elite IPK - Access Code (3-Digit) Assignment

2 - 60 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-1-48 Access Code (3-Digit) Assignment
General Description
Use this Memory Block to assign a 3-digit number as an Access Code.
With System Software R2500, Function 001 (Station Number) can be assigned
allowing 4-digit numbers by 10s group, 5-digit numbers by 100s group, 6-digit
numbers by 1000s group, or 7-digit numbers by 10000s group.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK1 + DH to access the Memory Block.
3 Enter the Function No. for Dial No. 0 for Third Digit Table No. 01 using the dial pad.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
B and J to enter ,
B and L to enter #
Default Values
All Dial 000 (Not Used)
4 Press G to write the data and display the next Dial No.
5 After last Dial No. entry, press
G to write the data and display Third Digit Table No. 02, Dial No. 0.
6 Enter Function No. for Dial No. 0, and press
G to write the data and display the next Dial No.
7 After last Dial No. entry for Table 02, press
G to write the data and display Third Digit Table No. 03, Dial No. 0.
8 Enter Function No. for Dial No. 0, and press
G to write the data and display the next Dial No.
9 After last Dial No. entry for Table 03, press
G to write the data and display Third Digit Table No. 04.
10 Enter Function No. for Dial No. 0, and press
G to write the data and display the next Dial No.
11 After last Dial No. entry for Table 04, press
G to write the data and display the next Memory Block.
12 Program next Memory Block or press
E to go back on-line.
System Mode
1
Submode
1
Data No.
48
PC Programming
¦ +BA
4 8 : 3 D G / 0 1 ( 0 ) = 0 0 0
T I M E D I S P L A Y
Function
No.
Data
No.
Third
Digit
Table
No.
(01~04)
Dial
No.
0~9
* #
Title