NEC Electra Elite IPK - MIF (Caller ID) Assignment

2 - 640 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
7-3-04 MIF (Caller ID) Assignment
General Description
Use this Memory Block to enable the ANI/Caller ID scrolling or outdial function on the
MIFM-U10/20 ETU or the SPE(M)-U( ) ETU. Basic Caller ID works without an
MIFM-U( ) ETU installed.
Display
 Notes 
Programming Procedures
1 Go off-line.
2 Press LK7 + LK3 +
JD to access the Memory Block.
3 Use the dial pad to enter data.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
 Setting Data: 00, 01, 02
Default Values
No Function (00)
4 Press G to write the data.
5 Press
E to go back on-line.
1. ANI/Caller ID scrolling and outdial must have the KMM(1.0)U installed on the MIFM-U10 ETU.
2. ANI/Caller ID scrolling and outdial must have the KMM-U20 installed on the MIFM-U20 ETU.
ETU Mode
7
MIF
3
Data No.
04
PC Programming
¦ +BS
0 4 : C L A S S M I F = 0 0
T I M E D I S P L A Y
Data
No.
Title
Setting
Data