1 - 8 Multiline Terminal Programming
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
2.5.3 Entering Programming Mode
The following digital Multiline Terminals can be used to program the
system. Station ports 01 and 02 are automatically assigned as
programming stations.
H
DTP or DTH/DTR-8D-1 TEL
H
DTU-8D-2 TEL
H
DTP or DTH/DTR-16D-1 TEL
H
DTU-16D-2 TEL
H
DTP or DTH/DTR-32D-1 TEL
H
DTU-32D-2 TEL
Using the DTH-16LD -1 TEL to program is not
recommended.
To enter programming mode, the station must be idle (on-hook).
Perform the following procedure to go off-line.
1. Press
A .
2. Press
H .
B
This key is used to enter a pause, hyphen, asterisk or pound. To enter
an asterisk or pound:
B +
J
=
,
B +
L
= #
B +
A
= A
B +
B
= B
B +
C
= C
The Message Waiting LED turns on and off after
J
or
L
is pressed.
E
Used to exit the programming mode (go back on-line).
G
Used to write (save) data. After entering data, press G ; the data is
written into memory. The next Memory Block is displayed.
Table 1-2 Multiline Terminal Keys Used for Programming
Key
Description
To Next Page
Loading...
