NEC Electra Elite IPK - 1-16-09 Low Priority TX Tag Assignment

Electra Elite IPK Document Revision 4
Programming Manual 2 - 397
___________________________________________________________________________________
___________________________________________________________________________________
1-16-09 Low Priority TX Tag Assignment
General Description
For frames marked at the ingress port by Memory Block 1-16-06 as Low Priority, this
memory block setting on the egress port assigns a value (0 ~7) to the priority field of
the VLAN tag. The default is 0.
R1500 or higher is required.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK16 +
JJKI to access the Memory Block.
3 Use dial pad keys to enter Setting data.
 Use the following to enter data:
Use
J to move cursor left
Use
L to move cursor right
Use
K ~ I to enter numeric data
 Priority range is lowest 0~7 highest.
Default Values
:
All ports = 0
4 Press G to write the data.
5 Repeat steps 3 and 4 for each port.
6 Press
E to go back on-line.
System Mode
1
Submode
16
Data No.
08
PC Programming
¦ +AB
System Mode
1
Submode
16
Data No.
09
PC Programming
¦ +AB
0 9 : 1 - 1 L O W T X = 0
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
PORT
1~8
HUB
1~3