NEC Electra Elite IPK - 8-Digit Matching Table to Trunk Group Assignment

Electra Elite IPK Document Revision 4
Programming Manual 2 - 611
___________________________________________________________________________________
___________________________________________________________________________________
5-02 8-Digit Matching Table to Trunk
Group Assignment
General Description
Use this Memory Block to assign each Trunk group to the 8-Digit Matching Tables.
Display
Settings
Page 1
Related Programming.
Refer to Chapter 3 Advanced Applications.
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
All are enabled
at default.
Table 00 Table 01 Table 02 Table 03 Table 04 Table 05 Table 06 Table 07
Page 2
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Table 08 Table 09 Table 10 Table 11 Table 12 Table 13 Table 14 Table 15
Programming Procedures
1 Go off-line.
2 Press LK5 +
G + KB to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Operation data includes:
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
C to go to the next page
A to go to the previous page
D to go to the next Trunk Group No.
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Trunk Group Mode
5
Submode
—
Data No.
02
PC Programming
¦ +AC
0 1 / 0 2 : 8 D G – T R K G | 1
T I M E D I S P L A Y
Title
Page
No.
Data
No.
Trunk
Group No.
(01~32)
CO/PBX
Line LED
Off On
Data Disabled Enabled
The shaded
selection is the
default.