NEC Electra Elite IPK - 1-13-01 PRT Signal Format Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 309
___________________________________________________________________________________
___________________________________________________________________________________
1-13-01 PRT Signal Format Selection
General Description
Use this Memory Block to specify the signal format of the PRT trunk connected to the system.
The signal format used (12- or 24-Multiframe) depends on the channel service unit/demarcation
(CSU/D mark) equipment being used.
Display
Settings
LK 1 LK 2LK 3LK 4LK 5LK 6LK 7LK 8
The shaded
selection is the
default.
12
(SF)
24
(ESF)
Programming Procedures
1 Go off-line.
2 Press LK1 + LK13 +
KA to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
G to write the data. The next Memory Block2 is displayed.
5 Program the next Memory Block2 or press
E to go back on-line.
System Mode
1
Submode
13
Data No.
01
PC Programming
¦ +AN
0 1 / 0 1 : F R A M E = 2 4
T I M E D I S P L A Y
Data
No.
Setting
Data
PRT
1~8
Title