NEC Electra Elite IPK - Tie Line Dial Tone Selection

2 - 456 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
3-27 Tie Line Dial Tone Selection
General Description
Use this Memory Block to specify whether or not to send a dial tone to the distant
system.
Display
Settings
LK 1 LK 2LK 3LK 4LK 5LK 6LK 7LK 8The shaded
selection is the
default.
NO YS
Programming Procedures
1 Go off-line.
2 Press LK3 +
G + BG to access the Memory Block.
3 Press Lk1 when you don’t want to send a dial tone to the distant system for CO/PBX No.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
3-14
Tie Line Type Assignment
CO/PBX Line Mod
e
3
Submode
—
Data No.
27
PC Programming
¦ +ALT
0 1 / 2 7 : S D T Y S
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Setting
Data