Electra Elite IPK Document Revision 4
Programming Manual 2 - 455
___________________________________________________________________________________
___________________________________________________________________________________
Notes
3 Press the corresponding CO/PBX line key to change signal detect timeout for CO/PBX No.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
C to go to the next page
A to go to the previous page
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
1. When the acknowledgment signal is not received in a programmed time after an outgoing signal is sent to the
other system, a busy tone is sent to the telephone.
2. This Memory Block affects T1 channels assigned to Tie/DID lines.
Programming Procedures (Continued)
Receiving Acknowledgment Signal
Sending an Outgoing Signal
Time
Timeout when the
acknowledgment
signal is not received.
Originating Side
To Next Page
Loading...
