NEC Electra Elite IPK - Trunk Type Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 499
___________________________________________________________________________________
___________________________________________________________________________________
3-91 Trunk Type Selection
General Description
Use this Memory Block to specify an external line as a CO, PBX/CTX, Tie, DID, or
CTX Assume - 9 line.
Display
Settings
 Notes 
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
The shaded
selection is the
default.
CO
PBX
(or CTX)
TIE DID
CTX
(Assume - 9)
Programming Procedures
1 Go off-line.
2 Press LK3 +
G + IA to access the Memory Block.
3 Press line key to specify trunk type for CO/PBX No.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
4 Press
G to write the selected data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
1. This Memory Block affects T1 channels assigned as Tie or DID lines.
2. Integrated Services Digital Network (ISDN) lines can be assigned as PBX/CTX or CTX Assume - 9. A CTX
Transfer does not work on ISDN lines.
CO/PBX Line Mod
e
3
Submode
—
Data No.
91
PC Programming
¦ +BCT
0 1 / 9 1 : C O
T I M E D I S P L A Y
Trunk
Type
Data
No.
CO/PBX
No.
(01~64)