NEC Electra Elite IPK - Tie Line Delay Ring Pattern Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 71
___________________________________________________________________________________
___________________________________________________________________________________
1-1-53 Tie Line Delay Ring Pattern Selection
General Description
Use this Memory Block to select a ringing pattern or no ring for incoming calls on a Tie
line after the timeout set in Memory Block 1-1-07 (Tie Line Delay Ringing Time
Selection).
Settings
Page 1
LK 1 LK 2 LK 3 LK 4LK 5LK 6LK 7LK 8
The shaded
selection is the
default.
A B C D E F G H
Page 2
LK 9 LK 10 LK 11 LK 12 LK 13 LK 14 LK 15 LK 16
NO
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
EC to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
 Use the following to enter data:
C to access the next page
A to access the previous page
4 Press
G to write data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
System Mode
1
Submode
1
Data No.
53
PC Programming
¦ +ALN
5 3 : T L I P T N D | 1
T I M E D I S P L A Y
Data
No.
Title
Page
No.
Setting
Data