NEC Electra Elite IPK - Route Advance Block Assignment

Electra Elite IPK Document Revision 4
Programming Manual 2 - 41
___________________________________________________________________________________
___________________________________________________________________________________
1-1-30 Route Advance Block Assignment
General Description
Use this Memory Block to assign a priority level (1~4) to each Trunk group assigned in
a Route Advance Block. The system has 32 blocks that can be specified.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK1 + CK to access the Memory Block.
3 Write data using one of the following.
 Press G repeatedly to cycle until desired Block and Priority number are
displayed. Use the dial pad to enter the Trunk Group Number, and press
G .
 Use the dial pad to select Block Number, Priority Number, and Trunk Group in
sequence, and press
G after Block 32 to display the next Memory Block.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
 Block Numbers:
Default Values
All Blocks (00)
4 Program the next Memory Block or press E to go back on-line.
System Mode
1
Submode
1
Data No.
30
PC Programming
¦ +BCS
3 0 : R T A D V 0 1 – 1 = 0 0
T I M E D I S P L A Y
Setting
Data
Title
Priority
No.
(1~4)
Data
No.
Block
No.
(1~32)
Block
No.
Priority
No.
Setting Data
1
1 Trunk Groups 01~32
2 Trunk Groups 01~32
3 Trunk Groups 01~32
4 Trunk Groups 01~32
32
1 Trunk Groups 01~32
2 Trunk Groups 01~32
3 Trunk Groups 01~32
4 Trunk Groups 01~32
~
~
~