NEC Electra Elite IPK - Tie Line Prepause Time Selection

2 - 440 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
3-16 Tie Line Prepause Time Selection
General Description
Use this Memory Block to specify the time (prepause) before the originating side can
send dial pulse or dual-tone multifrequency (DTMF) to the distant system.
Display
Settings
Page 1
 Notes 
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
The shaded
selection is the
default. Times
are in seconds.
0 0.5 1.0 1.5 2.0 3.0 4.0 5.0
Page 2
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
6.0 7.0 8.0 9.0 10.0 11.0 12.0 13.0
Programming Procedures
1 Go off-line.
2 Press LK3 +
G + AF to access the Memory Block.
3 Press the corresponding CO/PBX line key to change prepause time for CO/PBX No.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
C to go to the next page
A to go to the previous page
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
1. Prepause time differs according to the acknowledgment signaling method.
2. This Memory Block affects T1 channels assigned as Tie/DID lines.
CO/PBX Line Mod
e
3
Submode
—
Data No.
16
PC Programming
¦ +ALM
0 1 / 1 6 : P R E 0 | 1
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Setting
Data
Page
No.