NEC Electra Elite IPK - 1-16-13 VLAN Group to VLAN ID Assignment

Electra Elite IPK Document Revision 4
Programming Manual 2 - 405
___________________________________________________________________________________
___________________________________________________________________________________
1-16-13 VLAN Group to VLAN ID Assignment
General Description
Use this Memory Block to create a list of valid VLAN IDs to be recognized by the
HUB(8)-U( ) ETU.
R1500 or higher is required.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK16 +
JJAC to access the Memory Block.
3 Use dial pad keys to enter Setting data.
 Use the following to enter data:
Use
J to move cursor left
Use
L to move cursor right
Use
K ~ I to enter numeric data
 ID range is 0001~4095 (0x001~ 0xfff Hex).
Default Values
:
0000
4 Press G to write the data.
5 Repeat steps 3 and 4 for each HUB(8)-U( ) ETU and VLAN Group.
6 Press
E to go back on-line.
System Mode
1
Submode
16
Data No.
13
PC Programming
¦ +AB
1 3 : 1 1 D 0 1 = 0 0 0 0
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
VLAN Gp
01~16
HUB
1~3