NEC Electra Elite IPK - Automatic Day;Night Mode by Day of Week Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 43
___________________________________________________________________________________
___________________________________________________________________________________
1-1-32 Automatic Day/Night Mode by Day of
Week Selection
General Description
Use this Memory Block to select either Pattern 1 or Pattern 2 Day/Night Mode start
time for each day of the week. Memory Block 1-1-27 (Automatic Day/Night Mode
Switching Time Assignment) sets Day/Night Mode start time for Pattern 1 and Pattern
2 to switch the system between Day Mode and Night Mode.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Default not
assigned.
Sun Mon Tue Wed Thu Fri Sat
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK1 + CB to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Each time a CO/PBX line is pressed, the LED indication changes from Pattern 1 to
Pattern 2.
Default Values
Sunday ~ Saturday = Pattern 1
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
System Mode
1
Submode
1
Data No.
32
PC Programming
¦ +BM
3 2 : D / N B Y D A Y
T I M E D I S P L A Y
Title
Data
No.
CO/PBX
Line LED
Off On
Data
Day/Night
Automatic
Switching
Pattern 1
Day/Night
Automatic
Switching
Pattern 2
The shaded area indicates
the default setting.