NEC Electra Elite IPK - COM Port Baud Rate Setting Assignment

2 - 244 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-8-35 COM Port Baud Rate Setting
Assignment
General Description
Use this Memory Block to specify the baud rates for individual COM ports.
Display
Settings
 Notes 
LK 1LK 2LK 3LK 4 The shaded selection is the
default. Baud Rates are in
Kbps.
4.8 9.6 19.2 38.4
Programming Procedures
1 Go off-line.
2 Press LK1 + LK8 +
CE to access the Memory Block.
3
Press the corresponding CO/PBX line key to select the baud rate for each COM port
.
Default Values
COM 1 = 38.4
COM 2 = 4.8
COM 3 = 9.6
4 Press G to write the data, and advance to the next COM port.
5 Repeat steps 3 and 4 for each remaining COM port. The next Memory Block is displayed.
6 Program next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-5-13
Printer Connected Selection
COM 1 = PC Programming
COM 1 = LCR
COM 2 = Station Message Detail Recording (SMDR)
COM 3 = Automatic Call Distribution [Not used by Electra Elite IPK Basic Port Package (48).]
System Mode
1
Submode
8
Data No.
35
PC Programming
¦ +CSS
3 5 : B D R T 1 = 3 8 . 4
T I M E D I S P L A Y
Data
No.
3 5 : B D R T 1 = 3 8 . 4
T I M E D I S P L A Y
Setting
Data
Title