NEC Electra Elite IPK - Tie Line Networking Tandem Connection Assignment

Electra Elite IPK Document Revision 4
Programming Manual 2 - 609
___________________________________________________________________________________
___________________________________________________________________________________
5-01 Tie Line Networking Tandem
Connection Assignment
General Description
Use this Memory Block to specify whether or not Trunk groups connected to the
system allow incoming Trunk groups to be connected to outgoing Trunk groups for
tandem connections.
Display
Settings
Page 1
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default.
01 02 03 04 05 06 07 08
Page 2
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
09 10 11 12 13 14 15 16
Page 3
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
17 18 19 20 21 22 23 24
Page 4
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
25 26 27 28 29 30 31 32
Trunk Group Mode
5
Submode
—
Data No.
01
PC Programming
¦ +ALN
0 1 / 0 1 : T A N D E M | 0 1
T I M E D I S P L A Y
(Incoming)
Trunk Group
No.
(01~32)
Data
No.
Title
Trunk
Group