NEC Electra Elite IPK - Automatic Day;Night Mode Switching Time Assignment

Electra Elite IPK Document Revision 4
Programming Manual 2 - 37
___________________________________________________________________________________
___________________________________________________________________________________
1-1-27 Automatic Day/Night Mode Switching
Time Assignment
General Description
Use this Memory Block to assign a start time for Pattern 1 and a different start time for
Pattern 2 to automatically switch between Day Mode and Night Mode.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK1 + BG to access the Memory Block.
3 Enter the data using the dial pad.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
H to clear all data when the cursor is in the Data No. position
Default Values
Not Specified
4 Press G to write the data. The switching time for pattern 2 is displayed.
5 Use the dial pad to change the time.
6 Press
G to write the data and display the next Memory Block.
7 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-32
Automatic Day/Night Mode by Day of Week Selection
1-4-05
Automatic Tandem Trunk by Night Mode Selection
1-8-07
Class of Service (Attendant) Feature Selection I
1-8-48
Automatic Daylight Saving Time Selection.
4-07
Code Restriction Class Assignment (Day Mode)
4-08
Code Restriction Class Assignment (Night Mode)
4-09
Telephone to Tenant Assignment
System Mode
1
Submode
1
Data No.
27
PC Programming
¦ +BM
2 7 : 1 : , :
T I M E D I S P L A Y
Day Mode
Start Time
Setting
Data
N
igh
t M
ode
St
art
Tim
e
Set
tin
g
Dat
a
Data
No.
Pattern
(1/2)