NEC Electra Elite IPK - 1-11-03 IP K-CCIS Selection

2 - 292 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-11-03 IP K-CCIS Selection
General Description
Use this Memory Block to assign the IAD(8)-U( ) ETU used for K-CCIS over IP.
System Software R1500~R1700 or R2500 is required.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
NO YS
Programming Procedures
1 Go off-line.
2 Press LK1 + LK11 +
KC to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
G to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1
Card Interface Slot Assignment
1-15-05
Destination Point Code Transfer Assignment
1-15-06
Originating Office Code Number Assignment
1-15-07
K-CCIS Message Response Timeout Assignment
1-15-08
Link Reconnect Allow/Deny Selection
1-15-09
K-CCIS Maximum Call Forwarding Hop Assignment
1-15-11
Centralized Billing Allow/Deny Selection
1-15-12
Centralized Billing - Point Code of Center Office Assignment
1-15-13
Centralized Day/Night Switching for Remote Office Assignment
1-15-14
Centralized Day/Night Switching for Main Office Assignment
1-15-15
Centralized BLF Send Point Code Assignment
System Mode
1
Submode
11
Data No.
03
PC Programming
¦ +AD
0 1 / 0 0 : F R A M E = 2 4
T I M E D I S P L A Y
0 1 / 0 3 : C C I S o I P N O
T I M E D I S P L A Y
Data
No.
Setting
Data
DTI No.
(01~08)
Title