2 - 2 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-1-00 Pause Time Selection
General Description
Use this Memory Block to specify the pause time that can be inserted between digits
dialed on CO/PBX and Tie lines.
Display
Settings
Notes
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
1.0s 3.0s
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
KK
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-09
Manual Pause Selection
1-1-24
PBX/CTX Access Code Assignment I
1-1-25
PBX/CTX Access Code Assignment II
3-91
Trunk Type Selection
1. A pause is automatically inserted following a CO/PBX Access Code (e.g., 9) by programming CO/PBX lines as
PBX in Memory Block 3-91 (Trunk Type Selection) and 1-1-24/25 (PBX/CTX Access Code Assignment I/II).
2. Manual pauses can be stored for use when dialing outside lines by the Last Number Redial or Save/Store and
Repeat features using Memory Block 1-1-09 (Manual Pause Selection).
3. Pauses can be stored as part of System and Station Speed Dial buffers when needed.
System Mode
1
Submode
1
Data No.
00
PC Programming
¦
+BCM
0 0 : P A U S E 3 . 0 s
T I M E D I S P L A Y
Title
Data
Setting
Data
No.
To Next Page
Loading...
