NEC Electra Elite IPK - Internal Zone Paging Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 603
___________________________________________________________________________________
___________________________________________________________________________________
4-93 Internal Zone Paging Selection
General Description
Use this Memory Block to assign stations as Internal page zones.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
NO A B C
Programming Procedures
1 Go off-line.
2 Press LK4 +
IC to access the Memory Block.
3 Press the corresponding CO/PBX line key to select internal page zone for Tel Port No.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B + A to enter A for Port Numbers 100~109
B + B to enter B for Port Numbers 110~119
B + C to enter C for Port Number 120
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Telephone Mode
4
Submode
—
Data No.
93
PC Programming
¦ +BTM
Data
No.
0 1 / 9 3 : Z O N E N O
T I M E D I S P L A Y
Title
Tel
Port
No.
(01
~ C0)
Setting
Data