NEC Electra Elite IPK - CO;PBX Answer Key Operation Without Ringing Assignment (Night Mode)

2 - 568 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
4-53 CO/PBX Answer Key Operation
Without Ringing Assignment
(Night Mode)
General Description
Use this Memory Block to specify whether or not night assignment Answer key
operation uses ringing. When NO is selected, press the Answer key while an
incoming CO line key is flashing to answer the line key call. When YS is selected, the
telephone must be ringing for the Answer key to answer an incoming CO/PBX call.
Display
Settings
LK 1 LK 2LK 3LK 4LK 5LK 6LK 7LK 8The shaded
selection is the
default.
NO YS
Programming Procedures
1 Go off-line.
2 Press LK4 +
EC to access the Memory Block.
3 Press LK1 to press the answer key while an incoming CO line key is flashing to answer the call for Tel Port No.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B + A to enter A for Port Numbers 100~109
B + B to enter B for Port Numbers 110~119
B + C to enter C for Port Number 120
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Telephone Mode
4
Submode
—
Data No.
53
PC Programming
¦ +BTT
Data
No.
0 1 / 5 3 : R I N G N Y S
T I M E D I S P L A Y
Title
Tel
Port
No.
(01
~ C0)
Setting
Data