Electra Elite IPK Document Revision 4
Programming Manual 2 - 87
___________________________________________________________________________________
___________________________________________________________________________________
1-1-67 OCC Table Assignment
General Description
Use this Memory Block to assign an Other Common Carrier (OCC) code (8-digit
maximum) in a table. A maximum of 16 codes can be assigned.
Display
Related Programming
Refer to Chapter 3 Advanced Applications, Section 1 Code Restriction on page 3-1.
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
FG
to access the Memory Block.
3 Use the dial pad to enter the data.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data
H to clear data
The information that can be entered includes:
OCC Table: 01~16 (8-digit)
Setting Data: 0~9,
,
, #, NANP = X, P, N (Maximum eight digits)
Operation data includes:
Default Values
OCC Table 01 ~ 15 Blank
OCC Table 16 1010XXX
4 Press G to write the data and advance to the next OCC table.
5 Repeat Steps 3 and 4 for each OCC Table. The next Memory Block is displayed.
6 Program the next Memory Block or press
E to go back on-line.
System Mode
1
Submode
1
Data No.
67
PC Programming
¦
+AC
Data
No
6 7 : ( 0 1 ) =
T I M E D I S P L A Y
OCC
Table
01~16
Setting
Data
Operation
Data
Dial Number Operation
X
K
~
I
,
J
,
L
B +
G
P
K
and
A
B +
H
N
B
~
I
B +
I
,
J
B +
J
#
L
B +
L
To Next Page
Loading...
