NEC Electra Elite IPK - Tie Line Length of Delay Signal Selection

2 - 450 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
3-22 Tie Line Length of Delay Signal
Selection
General Description
Use this Memory Block to specify the time a delay pulse is sent to another system.
Display
Settings
Page 1
LK 1 LK 2LK 3LK 4LK 5LK 6LK 7LK 8
The shaded
selection is the
default. Times
are in
milliseconds.
0 300 600 900 1200 1500 1800 2100
Page 2
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
2400 2700 3000 3300 3600 3900 4200 4500
Programming Procedures
1 Go off-line.
2 Press LK3 +
G + BB to access the Memory Block.
3 Press the corresponding CO/PBX line key to change delay signal time for CO/PBX No.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
C to go to the next page
A to go to the previous page
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
G to go back on-line.
CO/PBX Line Mod
e
3
Submode
—
Data No.
22
PC Programming
¦ +ALM
0 1 / 2 2 : D E L Y 3 0 0 | 1
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Page
Setting
Data
Delay Pulse Sending
Receiving Signal Detection
Time
DC Loop Supervision
Receiving Side