NEC Electra Elite IPK - Telephone Mode Copy Assignment

Electra Elite IPK Document Revision 4
Programming Manual 2 - 623
___________________________________________________________________________________
___________________________________________________________________________________
6-4 Telephone Mode Copy Assignment
General Description
Use this Memory Block to enable copying data from one telephone port to another
telephone port or multiple consecutive telephone ports.
Display
Example: To copy data of telephone port 01 to telephone ports 20~30:
1. Enter the original Tel. No. Using the dial pad, press
KA .
2. Press
G .
Programming Procedures
1 Go off-line.
2 Press LK6 + LK4
to access the Memory Block.
3 Enter the Tel. Port No. to be copied.
 Use the following to enter data:
K ~ I to enter numeric data
H to clear all data when placed at cursor position
Copy Mode
6
Tenant
4
Data No.
—
T E L – – >
T I M E D I S P L A Y
Title
Setting
Data
Original
Tel Port No.
(01~CO)
T E L 0 1 – – >
T I M E D I S P L A Y
– – > T E L –
T I M E D I S P L A Y