NEC Electra Elite IPK - Clock;Calendar Setting

2 - 646 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
Clock/Calendar Setting
General Description
This Memory Block is used to set the time and date displayed on the Multiline
Terminals. Clock/Calendar must be set on a port 01 or port 02 assigned terminal.
Display
 Notes 
Programming Procedures
1 Press A .
2 Dial
I .
3 Dial L .
4 Dial current time (e.g.
KC:BI ).
5 Press C to toggle AM/PM.
6 Press
H to advance to the calendar.
7 Press
C to select the day of the week.
8 Dial
L to move the cursor to the day of the month setting.
9 Enter the date using the dial pad (
K ~ I ).
10 Press
C to select the month.
11 Dial
L to move the cursor to the year setting.
12 Enter the last two digits of the year using the dial pad (
K ~ I ).
13 Press
A .
1. This operation must be performed at port 01, or port 02 only.
2. The Clock/Calendar cannot be set using PC Programming.
3. To set the time only, press
A after Step 5.
System Mode
—
Submode
—
Data No.
—
PC Programming
1 1 : 0 8 A M
T I M E D I S P L A Y