NEC Electra Elite IPK - MIF (UCD) Assignment

Electra Elite IPK Document Revision 4
Programming Manual 2 - 639
___________________________________________________________________________________
___________________________________________________________________________________
7-3-03 MIF (UCD) Assignment
General Description
Use this Memory Block to enable the Uniform Call Distribution (UCD) function on the
MIFA-U( ) ETU.
Display
Programming Procedures
1 Go off-line.
2 Press LK7 + LK3 +
JC to access the Memory Block.
3 Use the dial pad to enter data.
 Use the following are used when entering data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
 Setting Data: 00, 01, 02
Default Values
No Assignment (00)
4 Press G to write the data.
5 Press
E to go back on-line.
ETU Mode
7
MIF
3
Data No.
03
PC Programming
¦ +BS
0 3 : U C D M I F = 0 0
T I M E D I S P L A Y
Data
No.
Title
Set tin g Da ta