NEC Electra Elite IPK - Voice Prompt to Tone Assignment

2 - 230 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-8-16 Voice Prompt to Tone Assignment
General Description
Use this Memory Block to assign the voice prompt to each tone. Voice prompt is
provided only during the Internal Dial tone or Call Waiting tone.
Display
Settings
Related Programming
Refer to individual features in the Electra Elite IPK Features and Specifications Manual.
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
PR1 PR2
Programming Procedures
1 Go off-line.
2 Press LK1 + LK8 +
AF to access the Memory Block.
3 Press the corresponding CO/PBX line key to change data option.
 Table No. 1: Dial tone
Table No. 2: Call Waiting tone
Default Values
Dial Tone: PR1
Call Waiting Tone: PR2
4 Press G to write the data and advance to Table 02.
5 After entering Table 2 data, press
G to write the data. The next Memory Block is displayed.
6 Program the next Memory Block or press
E to go back on-line.
System Mode
1
Submode
8
Data No.
16
PC Programming
¦ +AR
1 6 : 0 1 : D T = P R 1
T I M E D I S P L A Y
1 6 : 0 1 : D T = P R 1
T I M E D I S P L A Y
Tone
Name
Setting
Data
Table
No.
Data
No.