NEC Electra Elite IPK - CO;PBX Ringing Variation Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 433
___________________________________________________________________________________
___________________________________________________________________________________
3-07 CO/PBX Ringing Variation Selection
General Description
Use this Memory Block to specify a ringing tone for each CO/PBX line.
Display
Settings
 Notes 
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
The shaded
selection is the
default.
M
(Medium)
L
(Low)
H
(High)
Programming Procedures
1 Go off-line.
2 Press LK3 +
G + KG to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the ringing tone for CO/PBX.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-28
Distinctive Ringing by Telephone or CO Selection
1. This Memory Block is not applicable when Telephone is selected in Memory Block 1-1-28 (Distinctive Ringing by
Telephone or CO Selection).
2. High, medium, or low ringing tone applies to incoming outside line calls only.
CO/PBX Line Mod
e
3
Submode
—
Data No.
07
PC Programming
¦ +BCT
0 1 / 0 7 : D S T R I N G = M
T I M E D I S P L A Y
Setting
Data
CO/PBX
No.
(01~64)
Data
No.
Title