2 - 562 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
4-49 Caller ID Display for CAR Key
Assignment
General Description
Use this Memory Block to assign one Multiline Terminal per CAR to display ANI/Caller
ID Indication on incoming CAR calls.
This Memory Block is used for R1600 and lower. For R1700 or higher, it is no longer
required.
Display
Notes
Programming Procedures
1 Go off-line.
2 Press LK4 +
DI
to access the Memory Block.
3 Use the dial pad to enter Tel port No for CAR Port No. 01.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B +
A
to enter A for Port Numbers 100~109
B +
B
to enter B for Port Numbers 110~119
B +
C
to enter C for Port Number 120
Default Value
Not Specified
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
To display ANI/Caller ID Indication for normal incoming CO calls and CAR incoming calls, both ANI/Caller ID
Indication and Ring assignment must be assigned for the terminal in System Programming. A maximum of 15
Multiline Terminals can be assigned system-wide to display caller identification for normal incoming CO calls and
CAR incoming calls using Memory Block 1-1-78 (Caller ID Display Assignment for System Mode). A sixteenth
Multiline Terminal can be assigned to display ANI/Caller ID Indication for CAR incoming calls per CAR using this
Memory Block.
Telephone Mode
4
Submode
—
Data No.
49
PC Programming
¦
+AI
0 1 / 4 9 : C A L L I D 0 0
T I M E D I S P L A Y
Data
No.
CAR Port
No.
Title
Tel
Port No.
(01
~
C0)
To Next Page
Loading...
